Trividia True Metrix Air Self-Monitoring Blood Glucose Meter

How To Use Trividia True Metrix Blood Glucose Meter?

Blood Glucose Testing:

• Wash your hands with warm, soapy water. Dry thoroughly.
• Remove the test strip from a vial and close vial immediately. Insert strip into Test Port with black blocks facing up. The meter turns on.
• Lance your finger.
• With strip still in meter, touch tip of the strip to blood drop. Allow blood to be drawn into the strip.
• Remove strip from drop immediately after meter beeps and dashes appear across Meter Display
• Glucose result will be displayed with alternating date and time
• Hold meter in a vertical position with strip pointing down.
• Press Strip Release Button to discard the used strip from the meter.

Care Instructions:

• All parts of your blood glucose monitoring system could carry blood borne pathogens after use, even after cleaning and disinfecting.
• Cleaning and disinfecting the lancing device and the meter destroys most, but not necessarily all, blood-borne pathogens
• Wash your hands thoroughly with soap and warm water before and after handling the meter, lancing device, lancets, or test strips as contact with blood presents an infection risk.
• If the meter is being operated by a second person who provides testing assistance, the meter, and the lancing device should be disinfected prior to use by the second person.
• It is important to keep the meter clear and disinfected.

To Clean

• Wash hands thoroughly with soap and water.
• To Clean: Make sure meter is off and a test strip is not inserted.
• With ONLY PDI Super Sani-Cloth Wipes rub the entire outside of the meter using 3 circular wiping motions with moderate pressure on the front, back, left the side, right side, top, and bottom of the meter.
• Discard used wipes.

To Disinfect

• Using fresh wipes, make sure that all outside surfaces of the meter remain wet for 2 minutes.
• Make sure no liquids enter the Test Port or another opening in the meter.
• Let meter air dry thoroughly before using to test.
• Wash hands thoroughly again after handling meter.
• Verify that the System is working properly by performing an Automatic Self-Test (see Getting Started). Stop using the meter and call Customer Care for assistance if meter display appears cloudy or any display segments are missing, Markings on meter, including back meter label, are coming off or are missing, Buttons on the meter are hard to push or do not work, Unable to insert a test strip into Test Port, Automatic Self-Test gives an error message.
• Note: Other disinfectants have not been tested. The effect of other disinfectants used interchangeably has not been tested with the meter. Use of disinfectants other than Super Sani-Cloth Wipes may damage meter.

Customer Reviews