Skil-Care ChairPro Safety Alarm System

Skil-Care ChairPro Safety Alarm System

Brand/Manufacturer: SKIL CARE CORP
Save
  • FSA Approved

Skil-Care ChairPro Safety Alarm System helps prevent falls and wandering. The alarm activates if patient leaves or falls from chair and automatically resets when patient sits down. If features eight effective sensor sounds that alert caregiver.

Item # Desc Pkg Price
909367 ChairPro Safety Alarm System Each
$173.33
$128.43

Features

  • Skil-Care ChairPro Safety Alarm System includes:
    - Auto reset
    - Indicator light
    - Battery test
    - Low battery indicator
    - Battery
    - High-low volume
    - Buzzer tone
    - Cable strain relief
    - Protective bumpers
    - Mountable
  • Sounds: Two tone buzzer, high (90db), low (80db)
  • Two interfaces (connections): Modular (telephone type) for flat sensors and mini-plug for alternative sensors
  • Shock resistance bumpers

More Information

  • Note:
    -
    The alarm will not sound when the sensor pad wire (grey) is cut or accidentally pulled out unless it is activated. Also, when the sensor is activated by a resident sitting on it and the plug is accidentally pulled out it will ring but when re-inserted, the alarm will stop ringing. All of the conditions above apply either to the telephone type plug or mini-plug. The alarm sounds only when the mini-plug (black) is removed while sensor is activated. It will not ring when this wire is cut.
  • Operation:
    -
    Remove battery compartment cover on back of alarm unit and install two AA batteries, LED will light, steady.
    - Press battery test button. If alarm does not sound check battery connection and retest. If alarm fails to sound replace battery.
    a. This alarm has a low battery alert and an alarm will sound during a low battery condition
    - Insert telephone type plug into modular connection on the side of the alarm. Thread the cord through the Cable Stain Relief cavity LED will flash. Make sure that there is some slack so that if the cord is tugged it does not put pressure on the connector. Alarm will sound. Press Auto-Reset button to silence alarm.
    - Before using, test unit by pressing the palm of your hand firmly against the sensor pad. While doing this, check alarm to make certain that LED is flashing. Remove your hand. Alarm should sound. Press Auto-Reset button to silence alarm. If alarm fails to sound, make certain the telephone type plug is secure.
    - Select High or Low alarm volume using the switch on right side of alarm, and select Tone 1 or 2
    - When alarm is activated by the resident leaving the wheelchair, it maybe silenced by pressing the Auto-Reset button. The alarm is now in stand-by mode. The system will automatically go into the monitoring mode when the resident is reseated. There is no on or off switch.

Customer Reviews

Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*


Submit Cancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.rehab-store.com

Close