Enabling Devices Light, Vibration, Music Somatosensory Tube

How to Operate Enabling Devices Light, Vibration, Music Somatosensory Tube?

• Remove the vinyl end cap with the small hole on the top, by holding the tip of the cap and gently pulling and turning. Only one end cap will come off, exposing the battery compartment and speed controller.
• Pull the battery sleeve out of the tube by round cutout in its base.
• Remove the black battery case cover by unscrewing the Phillips head screw, then slide the cover off and install two AA batteries following proper (+) and (-) markings. Replace cove and screw and slide sleeve back in and reinstall the vinyl cap.
• While holding the tube at an upright angle, adjust the vibration speed control switch next to the round cutout starting from right to left, settings are as follows: HIGH/LOW/OFF vibration.
• Reinstall the vinyl cover over the end of the tube. Please Note: when re Please Note: when re-installing the battery sleeve installing the battery sleeve make sure to slide it just until it lines up with the end of the clear tubing. end of the clear tubing.
• Simply turn the Lights, Lights, Lights, Vibration Vibration Vibration& Music & Music & MusicSensory Sensory Tube to a vertical position to enjoy the soothing Tube vibrations and glowing lights.
• IMPORTANT NOTES: If the unit fails to operate, or operates incorrectly, the following steps should be performed:  Check batteries to ensure proper installation. If the unit still does not work correctly after the batteries are reconnected, replace all the batteries.  The lights on the tube do not shut off immediately, rather they fade out slowly once the tube is placed horizontally. horizontally.