Duralife DuraGlide Reclining Bath And Commode Transfer System Features
- Duralife DuraGlide Reclining Bath and Commode Transfer System with Seat has adjustable back and leg extension
- Duraglide is equipped with 4 locking 5" casters
- Easy-Level tub frame legs are infinitely adjustable over a 5³ range.
- Maximum Weight Limit: 250lb
- Product Dimensions: 48"L x 54"W x 50"
- Seat Dimensions - 17"(W) x 17"(D) x 22"(H)
- Product Weight: 35lb
Note: This product cannot be exchanged or returned due to hygiene reasons.
Duralife Product Care
All Duralife products are made from the highest quality furniture grade PVC pipe.
As with any healthcare product, it should be checked periodically for any damage occurring from daily use. Fittings and joints should be checked at this time also.
CLEANING INSTRUCTIONS
PVC Pipe
Use a soft cloth and wash with soap and water or any non-abrasive cleaner. Disinfectants may be used as required. Use alcohol or acetone on any deep scratches or markings. Swing armchairs are not watertight and disinfectant can be used inside the pipe. Let the solution drain out of the bottom of the chair before transporting.
Polyester Fabric
Prepare a cleaning solution using 1 tablespoon of liquid dish detergent and 2 tablespoons of household bleach mixed with 1 gallon of water. Use a sponge or soft cloth dampened in the solution. Remove the solution with a sponge or soft cloth and clean water. Use a brush in a circular motion to reach crevices. Disinfectants may be used as required.DO NOT TUMBLE DRY.
Casters
To install casters in a shower chair and other products:
- Turn product upside down on a protected surface.
- Align the caster stem with the hole in the caster socket and tap in with a soft-faced hammer. Casters should be lubricated on a routine basis with a silicone lubricant. Hair and any foreign material should be removed from around the axel.
- Drain holes in the bottom of the caster fittings should be checked for blockage. Insert a small wire in the hole to remove any accumulated debris.
Caution:- Products are made of plastic pipe. Do not store near a heat source.
- Instructions:
- Position the chair for patient transfer. Apply brakes on all casters. Transfer the patient to the bath seat.
- The seat and back are adjusted by depressing the locking buttons located under the seat and behind the back.
- Attach the bath seat and rolling base to the tub base and lock into place.
- Depress the lock release lever and slide the seat onto the tub base.
- Release the lock release lever and make sure it engages the tub base hole.
- For shipping purposes the adjusting pipes are taken apart.
- Start the smaller pipe into the larger pipe and depress the locking button. Slide together and adjust to desired position.
- Caution:
- Never leave patient unattended.
- Always apply all 4 brakes while transferring.
