Aqua Creek Revolution Pool Lift Anchor

More Information

• Anchor Installation (New Construction or Retro-Fit)

1. To properly install this anchor, you will need to have a concrete footing comprised of 2500 psi concrete that is 10 inches deep and 4 feet - 3 inches square and reinforced with rebar. Determine the location for the anchor based on the options you are ordering or think you may order in the future and set the anchor in place. You may use a small mass of wet concrete to set the anchor in place. Use level and string lines to make sure the anchor is perpendicular and will be flush with the top of the finished deck surface.
2. Bond the anchor according to local code requirements using the bonding lug on the bottom of the anchor. Reference the National Electric Code(NEC) Article 680.26for specifics on bonding. 
3. Pour the concrete so that the top of the anchor will be flush with the FINISHED pool deck surface. 
4. Once the concrete has cured, the lift can be put into place.

• ADA Fixing Insert Installation (Commercial Applications):

1. We recommend installation of the fixing insert after the concrete has cured and you are ready to install the lift into the anchor. 
2. Place the main assembly in the anchor. DO NOT LIFT THE MAIN ASSEMBLY BY USING THE ELECTRIC RAM AS A HANDLE. If the transport cart was ordered with the lift, it can be used effectively here. If not, use two people. 
3. Mark the location for the fixing anchor hole and remove the lift. 
4. Drill the hole with a 1-1/4 inch core drill or roto-hammer to a depth of about 4 -/2 inches. 
5. Clean the hole out and make sure it is dry. Thread the 1/2-inch bolt into the top of the PVC fixing anchor and test fit to verify it can be mounted perpendicular. 
6. Using a two-part construction epoxy, fill the hole approximately half full and carefully insert the PVC fixing anchor into the hole, twisting as you push down to evenly spread the epoxy. 
7. Allow the epoxy to cure before securing the lift. 
8. Re-install the lift into the anchor and using the 1/2 inch bolt and washer, carefully thread into the installed anchor until snug. TO PREVENT BREAKING THE FIXING BRACKET, DO NOT OVERTIGHTEN!

 WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

Customer Reviews